Woodworker's Journal Dry-Bar, страница 9

67. Glue the mitered pieces to the particleboard as shown.

68. Set the table saw fence to a height of 7/8".

69. Position the jig against the rip fence.

70. Locate the fence to make the first miter cut.

71. Pass the stock through the blade.

72. Cut splines to fit the grooves.

73. Glue in place.

74. Allow the glue to dry.

75. Hand plane the excess spline.

76. Sand flush.

77. Cut parts O and P and half-lap them at each end.

78. Sand all parts thoroughly, finishing with 220-grit sandpaper.

79. Assemble as shown. NOTE: Parts G and H are joined to part F with a single wood screw in each joint, while a pair of wood screws through each part D joins part J.

80. Use a dowel pin (I) to join the top unit (parts K, L, M, and N) to part B.

81. Final sand.

82. Apply two coats of Watco Danish Oil to complete the project.

These plans were originally published in Volume 8, Issue 2 of The Woodworker's Journal (Mar./Apr. 1984, pages 35-37).